User's Manual

Operations 110
Error code Error message Comment or clarification
3034
Operations on this Array are temporarily
unavailable while the Array is transforming.
The user requested too many simultaneous changes.
For example, the user added new disks to an array
(expand array) and changed the size or RAID level
of logical volumes on the array. The solution is for the
user to wait until the array transformation is
complete.
3035
Invalid value for NoBatteryWriteCache A problem exists with the
NOBATTERYWRITECACHE command. Check the
supplied argument. Not all controllers support this
operation.
3036
Cannot delete Logical Drive
A problem occurred during the attempt to delete the
specified logical drive. The drive may be in use by
the OS, it may not exist, or it may not be the last
logical drive on the array.
3038
The SplitMirror command is not valid for the
specified Array
The operation is not available. Older array
controllers/firmware may not support this command.
3046
This command is only available when
running offline
The operation requested cannot be performed
online. Boot to offline SSA Scripting and supply the
-offline parameter.
3047
Caching Volume parameters are not valid
for a data Volume
The parameters supplied are not applicable or valid.
3048
Invalid Spare Mode —
3049
Encryption Login Failed —
3050
Encryption Login command is not available —
3051
The Encryption command is not available —
3052
The Zeroize command failed The controller firmware returned an error when
attempting to set zeroize the encryption
configuration.
3053
The Firmware Lock/Unlock failed The controller firmware returned an error when
attempting to lock or unlock the firmware.
3054
Unable to change the Key Manager Mode The controller firmware returned an error when
attempting to change the key manager mode.
3055
Unable to set the Key Encrypting Key The controller firmware returned an error when
attempting to set Key Encrypting Key name.
3056
Unable to set the boot password The controller firmware returned an error when
attempting to set the boot password.
3057
Unable to set the boot password state The controller firmware returned an error when
attempting to set the boot password state.
3058
The controller does not support encryption An attempt was made to execute an encryption
command on a controller which does not support
encryption.
3059
Controller Encryption is disabled An attempt was made to execute an encryption
command when encryption was disabled.
3060
Login required for this Encryption command
A login is required before the encryption command
can be attempted.
3061
Plaintext volumes are not allowed The option to create future plaintext volumes was not
selected when initially configuring the encryption
configuration.
3062
Rekey of the encrypted volume failed The controller firmware returned an error when
attempting to rekey the selected logical volume.