User's Manual

Installing and uninstalling HP Serviceguard Toolkits for Database Replication
Solutions
DB2 HADR toolkit is part of the HP Serviceguard Toolkits for Database Replication Solutions and
is available on installing the HP Serviceguard Toolkits for Database Replication Solutions.
NOTE: The product name used for the depot is “Serviceguard Disaster Recovery Toolkits for
Databases”. However, the product name was changed to “HP Serviceguard Toolkits for Database
Replication Solutions” to match the functionality delivered.
To install the HP Serviceguard Toolkits for Database Replication Solutions:
1. Run the command:
# swinstall -s <depot path>
The “SD Install - Software Selection” user interface appears where you can select the product
that you want to install.
2. On the “SD Install - Software Selection” screen, mark the product, “T2259AA”.
3. To mark the product for installation:
a. Select Action > Mark For Install(m).
b. To install only a specific toolkit in “T2259AA”, see the options by pressing enter and
then select as appropriate.
4. Select Action >Install to initiate the installation.
To verify the installation completion, run the command:
# swlist -l product T2259AA
This command returns the list of toolkits that you selected during installation.
To uninstall the HP Serviceguard Toolkits for Database Replication Solutions, run the # swremove
T2259AA command.
Using the DB2 HADR toolkit
Supported configuration
This section explains the supported configuration for DB2 HADR toolkit. It includes the configuration
under the following scenarios:
Installing and uninstalling HP Serviceguard Toolkits for Database Replication Solutions 35