User's Manual

After setting up the Serviceguard environment, each clustered Oracle instance should have
the following files in the related package directory. For example, the ORACLE_TEST0 package,
located at /etc/cmcluster/pkg/ORACLE_TEST0, would contain the following files:
Table 5 Files in ORACLE_TEST0
DescriptionFile Name
Serviceguard package configuration file${SID_NAME}.conf
Serviceguard package control script${SID_NAME}.cntl
Toolkit Interface Scripttoolkit.sh
Toolkit user configuration filehaoracle.conf
Toolkit main scripthaoracle.sh
Oracle start/stop scripthaoracle_sql.sh
Toolkit Monitor Scripthalistener.mon
Listener Monitor Scripthalistener.mon
Another example to create the Serviceguard package using modular method:
1. Create the modular package configuration file "pkg.conf" by including the ECMT Oraclt toolkit
module.
# cmmakepkg -m ecmt/Oracle/Oracle pkg.conf
where,
'ecmt/Oracle/Oracle' is the ECMT Oracle toolkit module name.
pkg.conf is the name of the package configuration file.
2. Configure the following Serviceguard parameters in the pkg.conf file:
package_name — Set to any name desired.
package_type — Set to failover.
Edit the service parameters if necessary. The service parameters are preset to:
service_name Oracle_service
service_cmd "$SGCONF/scripts/ecmt/Oracle/tkit_module.sh Oracle_monitor"
service_restart none
service_fail_fast_enabled no
service_halt_timeout 300
service_name Oracle_listener_service
service_cmd "$SGCONF/scripts/ecmt/Oracle/tkit_module.sh Oracle_monitor_listener"
service_restart none
service_fail_fast_enabled no
service_halt_timeout 300
service_name oracle_hang_service
service_cmd "$SGCONF/scripts/ecmt/oracle/tkit_module.sh oracle_hang_monitor 30 failover"
service_halt_timeout 300
If the listener is not configured, comment the second set of service parameters which are used
to monitor the listener.
3. Configure the toolkit parameter TKIT_DIR. This parameter is synonymous to the package
directory. On a cmapplyconf, TKIT_DIR will contain the toolkit configuration file
haoracle.conf on all configured nodes. Configure the other toolkit parameters for the
database package .
4. Apply the package configuration using the following command:
# cmapplyconf -P pkg2.conf
This command creates the package using the values specified in the package configuration
file. It also creates the toolkit configuration directory defined by TKIT_DIR parameter on all
target nodes, if not already present and then creates the toolkit configuration file in it with the
values specified in thepkg.conf file.
Support For Oracle Database without ASM 25