Installation Guide

3. Create the configuration file for the VxVM 5.1 SP1 depot.
1. # cd /var/opt/ignite/data/Rel_B.11.31
2. # /opt/ignite/bin/make_config \
- s <1131_Vx*5.1_depot> – c <VX_config_filename>_cfg
3. Test the configuration file.
# /opt/ignite/bin/instl_adm –T –f <VX_config_filename>_cfg
4. Combine both configuration files into one Ignite-UX INDEX configuration clause:
1. # vi /var/opt/ignite/INDEX
2. Append a new configuration clause, such as:
cfg “HP-UX B.11.31_Mar2011_OE-Vx51” {
description “B.11.31_Mar2011_OE-Vx51 – 2 depots”
“/opt/ignite/data/Rel_B.11.31/config”
“/var/opt/ignite/data/Rel_B.11.31/<0E_config_filename>_cfg"
“/var/opt/ignite/data/Rel_B.11.31/<VX_config_filename>_cfg"
“/opt/ignite/data/Rel_B.11.31/hw_patches_cfg”
“/var/opt/ignite/config.local"
}
3. Test all the configuration files in the INDEX file.
# /opt/ignite/bin/instl_adm –T
5. If you plan to LAN boot the client, add its boot entry in the appropriate file on the server. This
step is not required if you plan to initiate the cold-install from the Ignite-UX server and the client
is up.
1. For an Intel® Itanium®-based client:
a. # vi /etc/bootptab
b. Upate the System-IPF entry with client_hostname and other relevant values.
2. For a PA-RISC client:
a. # vi /etc/opt/ignite/instl_boottab
b. Append an entry for the client using the following format:
<client_IP_addr>:<client_MAC_addr>::reserve # <client_hostname>
Cold-Installing the Client
To cold-install the client, complete the following steps:
1. Boot the client, whose hardware supports B.11.31. For a list of supported systems, see the
HP-UX 11i v3 Release Notes .
2. Use Ignite-UX to cold-install using the two depots referenced in the Ignite-UX server INDEX
configuration clause created above. In the Ignite-UX interface, make your selection in the Basic
tab, Configurationsline, such as HP-UX B.11.31_Mar2011_OE-Vx51.
3. Use the Ignite-UX interface to select the volume manager. On the Basic tab, File System line,
select the following:
VERITAS Volume Manager (VxVM) with VxFS
4. Use the Ignite-UX interface to select VxVM 5.1 SP1 and VxFS 5.1 SP1 software. On the
Software tab, select the following:
Base-VxFS-51 Veritas File System Bundle 5.1 for HP-UX
Base-VxTools-51 VERITAS Infrastructure Bundle 5.1 for HP-UX
Base-VxVM-51 Base VERITAS Volume Manager Bundle 5.1 for HP-UX
5. Use the Ignite-UX interface to deselect the VxVM 5.0 & VxFS 5.0 software, if it is selected.
On the Software tab, deselect the following:
32 Installing the Veritas 5.1 SP1 Products