- HP All in One Printer User Manual

     
   
      
  
Carriage-motor
connector
1
2
Tensioner wheel
Small drive belt
Motor gear
Double pulley
Loosen
 Remove the electronicsĆenclosure
cover  page 6Ć5.
 Remove the window  page 6Ć15.
 Remove the center cover  page 6Ć16.
 Remove the right endcover  page 6Ć19.
Torx-15
 Disconnect the carriageĆmotor cable from
the main PCA (connector labelled Y), and
from the lowest ferrite holder on the
rightĆhand side of the plotter.
 Pressing the small drive belt against the
tensioner wheel in the belt tensioner to
loosen the belt, slide the belt off of the
motor gear; then carefully release your
hand from the the tensioner wheel.
 Loosen the two carriageĆmotor screws
about 1/2 cm (about 1/4 inch).
6Ć35 Removal and ReplacementC3187Ć90000
    