- HP All in One Printer User Manual

 Remove the two screws that secure the
media motor to the mediaĆmotor mount.
 Pull the media motor towards the rear of
the plotter.
 Disconnect the flat encoder cable from
the motor, and lift the motor clear of the
plotter.
Torx-15
Calibration: After having reassembled the
plotter, perform the accuracy calibration
(Details  chapter 7.)
Reassembling: The worm pinion and
driveĆroller gear mesh slightly during use.
Don't install a new motor and an old gear,
or vice versa: install the gear that comes
with the motor. Apply the grease that
comes with the new motor to the worm
pinion and driveĆroller gear.
6Ć38 Removal and Replacement
C3187Ć90000