User Manual

SP88W8782UMA0 2.4 GHz v2.0 (SDGOB-1291, 1150-7959)
User Guide
Doc. No. MV-SR00222-13 Rev. – Copyright © 2012 Marvell
Page 18 Document Classification: Proprietary February 3, 2012, 1.00
B.2 Canadian Regulatory Wireless Notice
B.2.1 English
This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the
following two conditions:
1) this device may not cause interference and
2) this device must accept any interference, including interference that may cause undesired
operation of the device
IMPORTANT NOTE:
IC Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator
and your body.
This device is intended only for Applicant integrators under the following conditions:
1) The antenna must be installed such that 20 cm is maintained between the antenna and users,
and
2) For all products market in IC, Applicant has to limit the operation channels in CH1 to CH11 for
2.4G band by supplied firmware programming tool. Applicant shall not supply any tool or info to the
end-user regarding to Regulatory Domain change.
As long as 2 conditions above are met, further transmitter test will not be required. However, the
Applicant integrator is still responsible for testing their end-product for any additional compliance
requirements required with this module installed.
IMPORTANT NOTE:
In the event that these conditions can not be met (for example certain laptop configurations or
co-location with another transmitter), then the IC authorization is no longer considered valid and the
IC ID can not be used on the final product. In these circumstances, the Applicant integrator will be
responsible for re-evaluating the end product (including the transmitter) and obtaining a separate IC
authorization.
End Product Labeling
This transmitter module is authorized only for use in device where the antenna may be installed such
that 20 cm may be maintained between the antenna and users. The final end product must be
labeled in a visible area with the following: “Contains IC: 466D-SDGOB291”.
Manual Information To the End User
The Applicant integrator has to be aware not to provide information to the end user regarding how to
install or remove this RF module in the user’s manual of the end product which integrates this
module.
The end user manual shall include all required regulatory information/warning as show in this
manual.