User Manual

Federal Communication Commission Interface (FCC) Compliance
Copyright © 2012 Marvell Doc. No. MV-SR00222-13 Rev. –
February 3, 2012, 1.00 Document Classification: Proprietary Page 17
IMPORTANT NOTE:
In the event that these conditions can not be met
(for example certain laptop configurations or
co-location with another transmitter), then the FCC authorization is no longer considered valid and
the FCC ID can not be used on the final product. In these circumstances, the Applicant integrator will
be responsible for re-evaluating the end product (including the transmitter) and obtaining a separate
FCC authorization.
End Product Labeling
This transmitter module is authorized only for use in device where the antenna may be installed such
that 20 cm may be maintained between the antenna and users. The final end product must be
labeled in a visible area with the following: “Contains FCC ID: B94SDGOB1291”.
Manual Information To the End User
The Applicant integrator has to be aware not to provide information to the end user regarding how to
install or remove this RF module in the user’s manual of the end product which integrates this
module.
The end user manual shall include all required regulatory information/warning as shown in this
manual.