User's Manual
Table Of Contents
- Introduction / Requirements
- Installation
- Login
- Keycode Entry
- Hardware Configuration
- Printers / Queues
- The Configuration Wizard
- Create Queue
- Create Printer Cluster
- Preferences
- Menu Bar Options
- Reprocontrol.client main applications
- Filter Editor
- Functions and Structure of the Filter Editor
- Preview of the Filter Editor
- Histogram
- Tab Black and White Point (Color Mode without Color Management)
- Tab Postprocessing (Black & White Mode)
- Tab Gamma Correction (Color Mode without Color Management)
- Tab Enhancement (Color Mode with Color Management)
- Tab Special Filter (All Modes except of Black & White Mode)
- Tab Color Adjust (Color Mode with Color Management)
- Tab Color Exchange (Color Mode with Color Management)
- Functions and Structure of the Filter Editor
- Reprocontrol.WinDriver
- Reprocontrol.monitor
- Costtracker
- Reprocontrol.backup
87
Calibration of the costtracker
First read the current amount of ink either from the printer’s panel if this is supported by the printer.
If not weigh the ink tanks.
Please output the test file 10_Grafik_6_farben.tif 10 times in the print mode you want to calibrate on the medium.
The coverage is 20%.
Then measure the amount of ink used either by reading the panel again or weighing the tanks.
Calculate the used ink amount. 1 ml is about 1 g.
Determine the value you have to insert in the costtracker using following formula:
Used ink
-------------------------------------
coverage x number of prints