Installation Manual

3. Use the SAS Utility to confirm the connectivity of SAS devices visible through the SAS port.
For example:
Example 2-2 Using SAS$UTIL to Confirm SAS Devices
$ RUN SYS$SYSTEM:SAS$UTIL
SAS> SET ADAPTER PKB0
1
Selected controller _PKC0: is a LSISAS10xx device.
SAS> SHOW DISK
2
Port _PKC0:
---- --- --- --- -------- ------- -------- ------------------ -----------------
ID Enc PHY Slt Device Type Size(MB) SAS Address Product Name
---- --- --- --- -------- ------- -------- ------------------ -----------------
09 02 01 02 DGA-1 SAS 34732 5000C500-00F537E5 HP DH036.. HPD2
10 02 02 03 DGA-1 SAS 34732 5000C500-00F5F36D HP DH036.. HPD2
33 02 36 26 - SAS 0 500110A0-0077D125 HP MSA70.. 2.06
1
Issuing the SET ADAPTER command to specify the AH303A SAS controller, using
the adapter ID from the previous step.
2
Issuing the SHOW DISK command to display information about devices connected
to the AH303A.
For More Information
For more information on configuring SAS devices on the AH303A adapter, see the SAS Controller
section of the HP OpenVMS System Management Utilities Reference Manual. For more information
about booting Shared Serial Attached SCSI devices on OpenVMS, see the Guidelines for OpenVMS
Cluster Configurations. These documents are available at:
http://www.hp.com/go/openvms/doc
22 OpenVMS Installation