Installation Manual

12. In the Documents column next to the Download Software column, click
Download/Installation Instructions to view instructions for using the swinstall tool to
install the drivers, utilities, and manpages.
Installing Software
The drivers, utilities, and manpages for SAS controllers are contained in the CommonIO and
SerialSCSI-00 bundles located in the downloaded depots. See “Downloading Software” (page 12).
Follow the procedure in the Download/Installation Instructions to verify the download and
install the bundles.
IMPORTANT: You must install the CommonIO bundle before the SerialSCSI-00 bundle.
Installing the Adapter Hardware Offline
This section describes the procedures to install the AH303A adapter offline.
CAUTION: Electronic components can be damaged by small amounts of static electricity. To
avoid damage, follow the guidelines in Appendix A (page 23).
Preparing the server
To prepare the server for offline installation of the AH303A adapter, follow these steps:
1. Perform a normal system shutdown.
2. Power off the server.
3. Power off all peripheral devices attached to the server.
4. Unplug the AC power cord from the outlet, and then unplug it from the server.
5. Disconnect all peripheral devices attached to the server.
Installing the Adapter
To install the adapter, follow these steps:
1. Depending on the server model, remove or open the server access panel.
For detailed instructions, see the documentation for your server at:
http://docs.hp.com/en/hw.html
WARNING! To reduce the risk of personal injury or damage to the equipment, consult the
safety information and user documentation provided with the server before attempting the
installation. Many servers can produce energy levels that are hazardous. The servers are
intended to be serviced by qualified personnel trained to deal with these hazards. Do not
remove enclosures or attempt to bypass interlocks that might be provided for removing
these hazardous conditions.
WARNING! To reduce the risk of personal injury from hot surfaces, allow the internal
system components to cool before touching them.
2. Locate the PCIe bus expansion slots, and select the slot that you want to use.
For more information, see the server documentation.
3. Depending on the server model, remove the retaining screw or open the expansion slot latch
that secures the PCIe slot.
4. Remove the slot cover and save it.
You must put it back if you decide to remove the adapter and leave the slot empty.
Installing Software 13