User's Manual

Figure 2 Opening and converting SAN Design file
.
If the SAN Design profile created using SAN Designer 1.5 contains obsolete SAN components, you
will be prompted to redesign the SAN by replacing them with alternate SAN components, as shown
in Figure 3. Click Yes to remove obsolete SAN components and open the file in SAN Designer 1.6.
NOTE:
Once you have removed all the obsolete SAN components, you cannot open it using SAN Designer
1.5.
Figure 3 Opening SAN Design containing obsolete SAN components
.
If the SAN Design profile created using SAN Designer 1.5 contains SAN components that are not
supported by SAN Designer 1.6, you will be prompted to redesign the SAN by replacing them with
alternate SAN components, as shown in Figure 4. Click Yes to remove unsupported SAN components
and open the file in SAN Designer 1.6.
NOTE:
Once you have replaced all the unsupported SAN components, you cannot open it using SAN Designer
1.5.
HP Storage SAN Designer 1.6 User Guide 13