User Manual
Table Of Contents
- Contents
- Introducing the ProCurve Wireless Access Point 10ag
- Installing the Access Point
- Before You Begin
- Installation Precautions
- Summary of Installation Tasks
- Installation Procedures
- Getting Started With Access Point Configuration
- Setting Up the Access Point
- Configuring Basic Settings
- Configuring Basic Wireless Settings
- Configuring the Security Settings
- Controlling Access to the Wireless Network
- Configuring Advanced Wireless Settings
- Setting the SNMP Community Names
- Managing the Access Point
- Troubleshooting
- Specifications
- Access Point Port and Network Cables
- Safety and EMC Regulatory Statements
- Open Source Licenses
- Recycle Statements
5-9
Managing the Access Point
Rebooting the Access Point
Managing the Access Point
6. Click OK to restore settings from the backup file and overwrite the
current settings. The message Please wait... appears as the access point
restores the backup configuration file. When the access point has
completed the restore process, the following message appears:
AP is rebooting......
PLEASE WAIT until re-directed to Information page.
The browser page refreshes, and the Information page appears.
Rebooting the Access Point
If you feel that the Access Point is not operating normally, try rebooting the
device. This clears memory resources in use and can help restore normal
operation.
Note that rebooting the Access Point will temporarily disconnect any wireless
stations that are connected to it. If you have users on the network that are
connected to the Internet through the Access Point, they will be temporarily
disconnected. Their connection will be restored as soon as the Access Point
has completed rebooting.
You can reboot the access point by pressing the Reset to Default button (on
the rear of the access) for one to three seconds. Alternatively, you can click
Reboot AP on the Web interface to perform the same action.
Refer to the procedure below for instructions on how to reboot the access
point from the Web interface.