User's Manual
Table Of Contents
- Introducing the ProCurve Wireless Access Point 420
- Installing the Access Point 420
- Included Parts
- Installation Procedures
- Summary
- Installation Precautions:
- 1. Prepare the Installation Site
- 2. Verify the Access Point Passes the Self Test
- 3. Mount the Access Point
- 4. Connect the Access Point to a Power Source
- 5. Connect the Network Cable
- 6. Position the Antennas on the Access Point
- 7. (Optional) Connect a Console to the Access Point 420
- Sample Network Topologies
- Getting Started With Access Point Configuration
- Using an External Antenna with the Access Point 420
- Troubleshooting
- Specifications
- Access Point Port and Network Cables
- Safety and EMC Regulatory Statements
- Recycle Statements
C-9
Safety and EMC Regulatory Statements
EMC Regulatory Statements
Safety and EMC Regulatory
Statements
EMC Regulatory Statements
Notice for U.S.A.
Manufacturer's FCC Declaration of Conformity Statement
Product No: J8130B
FCC ID No: B94RSVLC-0301B
Manufacturer: Joy Technology (Shenzhen) Co. Ltd.
Hengkeng Industrial, Shangpai, Shangwu, Aiqun Rd.,
Shiyan Town, Shenzhen 518108,
P. R . C h i n a
Phone: +86-0755-33816888
For questions regarding this declaration, contact the Product Regulations
Manager at the above address or phone number.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with instruc-
tions, may cause harmful interference to radio communications. However,
there is no guarantee that the interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
■ Reorient the receiving antenna
■ Increase the separation between the equipment and receiver
■ Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected
■ Consult the dealer or an experienced radio/TV technician for help
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: 1) this device may not cause harmful interfer-
ence, and 2) this device must accept any interference received, including
interference that may cause undesired operation.
Tested to Comply
with FCC Standards