User's Manual
Table Of Contents
- Introducing the ProCurve Wireless Access Point 420
- Installing the Access Point 420
- Included Parts
- Installation Procedures
- Summary
- Installation Precautions:
- 1. Prepare the Installation Site
- 2. Verify the Access Point Passes the Self Test
- 3. Mount the Access Point
- 4. Connect the Access Point to a Power Source
- 5. Connect the Network Cable
- 6. Position the Antennas on the Access Point
- 7. (Optional) Connect a Console to the Access Point 420
- Sample Network Topologies
- Getting Started With Access Point Configuration
- Using an External Antenna with the Access Point 420
- Troubleshooting
- Specifications
- Access Point Port and Network Cables
- Safety and EMC Regulatory Statements
- Recycle Statements
A-2
Specifications
Specifications
Connectors
■ The 10/100 Mbps RJ-45 twisted-pair port is compatible with the
IEEE 802.3u 100Base-TX and IEEE 802.3 Type 10Base-T standards.
Note: To provide Power over Ethernet to the access point, all 4 pairs of
wires must be connected for any network cable attached to this port.
Safety
Complies with:
■ EN 60950-1
EMC Compliance (Class B)
Complies with:
■ FCC Part 15.107
■ ICES-003 (Canada)
■ EN 55022
■ VCCI
Telecom
Complies with:
■ FCC Part 15.247 (2.4GHz)
■ RSS-210 (Canada)
■ EN 300.328
■ MPT RCR Std. 33 (D33 1~13 Channel, T66 Channel 14)
Immunity
■ EN 301.489-1
■ EN 301.489-17