User's Manual
Table Of Contents
- Introducing the ProCurve Wireless Access Point 420
- Installing the Access Point 420
- Included Parts
- Installation Procedures
- Summary
- Installation Precautions:
- 1. Prepare the Installation Site
- 2. Verify the Access Point Passes the Self Test
- 3. Mount the Access Point
- 4. Connect the Access Point to a Power Source
- 5. Connect the Network Cable
- 6. Position the Antennas on the Access Point
- 7. (Optional) Connect a Console to the Access Point 420
- Sample Network Topologies
- Getting Started With Access Point Configuration
- Using an External Antenna with the Access Point 420
- Troubleshooting
- Specifications
- Access Point Port and Network Cables
- Safety and EMC Regulatory Statements
- Recycle Statements
5-9
Troubleshooting
Restoring the Factory Default Configuration
Troubleshooting
To execute the factory default reset on the access point, perform these steps:
1. Using a pointed object, press and hold the Reset button on the back of the
access point for 5-10 seconds. On the console display, the cursor will move
down to the next line, indicating that the factory defaults have been
reloaded.
2. Release the Reset button.
The access point will then complete its self test and begin operating with
its configuration restored to the factory default settings.
To restore the factory default configuration using the console, execute the
reset configuration command from the console command prompt.