User's Manual

3-7
Getting Started With Access Point Configuration
Getting Started With Access
Point Configuration
Here is some information on the basic IP address and wireless configuration
parameters. For more information on these parameters, see the Management
and Configuration Guide, which is on the Documentation CD-ROM that came
with your access point:
Parameter Default
Username admin The name of the manager.
Password none The password for the manager.
IP Address 192.168.1.1 IP address compatible with your network.
Subnet Mask 255.255.255.0 Subnet mask compatible with your network.
Default Gateway 192.168.1.254 IP address of the next-hop gateway node for network traffic that needs to be
able to reach off-subnet destinations.
Primary SSID Enterprise
Wireless AP 1
The primary Service Set Identifier (SSID) interface for the access point. Only
the primary SSID is broadcast in the access point’s beacon frames.
Channel 0 (AUTO) The radio channel through which the access point communicates with its
wireless clients. When attempting to connect, most wireless clients
automatically set their radio channel to the same channel used by the access
point.
Wireless Operation Disabled Wireless operation can only be enabled after you have set the country code.
Note: The IP address and subnet mask assigned for the access point must be compatible with the IP addressing used
in your network. For more information on IP addressing, see the Management and Configuration Guide, which is on
the Documentation CD-ROM that came with your access point.