User's Manual
Table Of Contents
- Introducing the ProCurve Wireless Access Point 420
- Installing the Access Point 420
- Included Parts
- Installation Procedures
- Summary
- Installation Precautions:
- 1. Prepare the Installation Site
- 2. Verify the Access Point Passes the Self Test
- 3. Mount the Access Point
- 4. Connect the Access Point to a Power Source
- 5. Connect the Network Cable
- 6. Position the Antennas on the Access Point
- 7. (Optional) Connect a Console to the Access Point 420
- Sample Network Topologies
- Getting Started With Access Point Configuration
- Using an External Antenna with the Access Point 420
- Troubleshooting
- Specifications
- Access Point Port and Network Cables
- Safety and EMC Regulatory Statements
- Recycle Statements
2-8
Installing the Access Point 420
Installation Procedures
Installing the
Access Point 420
Note If mounting the access point in an air conditioning or heating duct, leave the
cover on to aid in mounting the unit on the bracket as described in the
preceding steps. The unit’s plastic cover should then be removed for safety
reasons.
Mounting the Bracket on a Wall
Sliding the Access Point onto the Bracket
5/8-inch
wood screws
Alignment slots
Mounting
points
Retaining
latches
Mounting
slots
Alignment tabs