User's Manual
Table Of Contents
- Introducing the ProCurve Wireless Access Point 420
- Installing the Access Point 420
- Included Parts
- Installation Procedures
- Summary
- Installation Precautions:
- 1. Prepare the Installation Site
- 2. Verify the Access Point Passes the Self Test
- 3. Mount the Access Point
- 4. Connect the Access Point to a Power Source
- 5. Connect the Network Cable
- 6. Position the Antennas on the Access Point
- 7. (Optional) Connect a Console to the Access Point 420
- Sample Network Topologies
- Getting Started With Access Point Configuration
- Using an External Antenna with the Access Point 420
- Troubleshooting
- Specifications
- Access Point Port and Network Cables
- Safety and EMC Regulatory Statements
- Recycle Statements
2-5
Installing the Access Point 420
Installation Procedures
Installing the
Access Point 420
2. Verify the Access Point Passes the Self Test
Before mounting the access point in its network location, you should first
verify that it is working properly by plugging it into a power source, or
connecting it to a switch that provides Power over Ethernet, and verifying that
it passes its self test.
1. Connect a network cable from a PoE source device (such as a switch) to
the RJ-45 port on the back of the access point, or connect the supplied
power adapter to the power connector on the back of the access point,
and then into a properly grounded electrical outlet.
Note The Access Point 420 does not have a power switch. It is powered on when
the power adapter is connected to the access point and to a power source, or
when a network cable is connected to the access point and to a network device
that provides Power over Ethernet. For safety, when connecting to an elec-
trical outlet, the power outlet should be located near the access point.
Use only the AC power adapter supplied with the access point. Use of other
adapters, including adapters that came with other ProCurve Networking
products, may result in damage to the equipment.
3.3V 4A
Console 10/100Base-TX
Reset
hp procurve
wireless AP
420 na
J8130B
Or connect power adapter
to the power connector
Connect network
cable to PoE switch