Specifications

Chapter 5
Server Troubleshooting
Server LED Indicators
167
Core I/O LEDs
The core I/O LEDs are located on the bulkhead of the installed core I/O PCA. See Table 5-7 on page 168 to
determine status and description. There is a DIP switch on the core I/O card that is used to select which MP
firmware set (indicated by the MP SEL LED) is selected for loading. The DIP switch is only visible when the
core I/O card is removed from the system and is located in the center of the PCA.
Figure 5-7 Core I/O Card Bulkhead LEDs
SCSI Term
SCSI LVD
ATTN
Power
Locate
Reset
Active
MP Power
10=OFF/100=ON
Act/Link
10=OFF/100=GRN/1000=ORNG
Act/Link