Hardware Reference Manual
Table Of Contents
- Product Features
- Hardware Upgrades
- Tools Needed
- Warnings and Cautions
- Mounting the RP7 to a Wall or Swing Arm
- Installing the RP7 Adjustable Stand
- Routing Cables to External Devices
- Installing Optional Integrated USB Modules
- Installing an Optional HP Retail RP7 10.4” Customer Display
- Installing an Optional HP Retail RP7 VFD Customer Display
- Installing Additional Memory
- Removing and Installing a Hard Drive
- Replacing the Battery
- Using the USB Security Cover
- Securing the RP7 to a Counter Top
- Installing an External Security Lock
- Configuring the Software
- Troubleshooting
- Electrostatic Discharge
- Computer Operating Guidelines, Routine Care and Shipping Preparation
- Index
4. There are two screw holes on the base of the stand. Fasten the stand to the counter top using
the appropriate fastening devices for your surface.
NOTE: HP supplies wood screws for securing the base to a wooden surface.
5. Replace the power supply cover by lowering it down over the neck of the base then sliding it
back until it snaps in place.
6. Reconnect the power cord and press the power button.
Installing an External Security Lock
Cable Lock
A Cable Lock can be used to secure the RP7 rear panel and fix it to an external object.
ENWW Installing an External Security Lock 57