Hardware Reference Manual

Securing the RP7 to a Counter Top
1. Turn off the computer properly through the operating system, then turn off any external devices.
2. Disconnect the power cord from the power outlet.
CAUTION: Regardless of the power-on state, voltage is always present on the system board
as long as the system is plugged into an active AC outlet. You must disconnect the power cord
to avoid damage to the internal components of the computer.
3. Pull the power supply cover back then lift if up and off the unit.
4. There are two screw holes on the base of the stand. Fasten the stand to the counter top using
the appropriate fastening devices for your surface.
NOTE: HP supplies wood screws for securing the base to a wooden surface.
Securing the RP7 to a Counter Top 57