User's Manual

Programming User Preferences
User Guide www.hp.com 5–7
Laser On Time
This parameter sets the maximum time that decode processing
continues during a scan attempt. It is programmable in 0.1 second
increments from 0.5 to 9.9 seconds. The default Laser On Time
is 3.0 seconds.
To set a Laser On Time, scan the bar code below. Next, scan two
numeric bar codes in Chapter 8, “Numeric Bar Codes,” of the
Programming Reference Guide, that correspond to the desired on
time. Single digit numbers must have a leading zero. For
example, to set an On Time of 0.5 seconds, scan the bar code
below, then scan the “0” and “5” bar codes. If you make an error,
or wish to change your selection, scan Cancel.
Laser On Time