Hardware Reference Manual

b. To insert the new battery, slide one edge of the replacement battery under the holder’s lip
with the positive side up (1) and press the other edge down into the holder so that it snaps
in place (2).
Figure 2-69 Removing and Replacing a Coin Cell Battery (Type 1)
Type 2
a. To release the battery from its holder, squeeze the metal clamp that extends above one
edge of the battery. When the battery pops up, lift it out (1).
b. To insert the new battery, slide one edge of the replacement battery under the holder’s lip
with the positive side up. Push the other edge down until the clamp snaps over the other
edge of the battery (2).
Figure 2-70 Removing and Replacing a Coin Cell Battery (Type 2)
NOTE: After the battery has been replaced, use the following steps to complete this procedure.
8. Replace the computer access panel.
9. Reconnect the power cord and any external devices, then turn on the computer.
10. Reset the date and time, your passwords, and any special system setups using Computer
Setup.
11. Lock any security devices that were disengaged when the computer access panel was removed.
58 Chapter 2 Hardware Upgrades