Manualshelf

Hardware Reference Manual

ManualsBrandsHP ManualsPoint of Sale SystemsHP RP3 Retail System Model 3100 Base Model
31323334353637383940
11. To install the hard drive in the carrier, align the mounting screws with the slots on the carrier,
press the drive straight down into the carrier, then slide the drive back so that it locks inside the
carrier. Ensure that the drive is properly seated in the carrier with the retention arm all the way
down in the locked position.
Figure 2-32 Installing the Hard Drive in the Carrier
12. To place the hard drive carrier back in the chassis, align the mounting screws with the slots on
the top and bottom of the chassis then press the carrier against the rear panel and slide the
drive toward the outside of the chassis until it locks in place.
Figure 2-33 Installing the Hard Drive Carrier
28 Chapter 2 Hardware Upgrades