Compaq StorageWorks Fibre Channel Troubleshooting Guide

4 Compaq StorageWorks Fibre Channel Troubleshooting Guide
P
panels
rear 1-14
PCI
(/P) 2-2
bus 1-4
Host Bus Adapter 2-2
PCI bus See PCI
PLDA 1-20
power status light A-7
primary storage flow chart
overview 4-2
some Fibre Array Controllers
are detected 4-7
verify system operation 4-4
primary storage flow charts
determine a bad link 4-6
primary storage flowchart
Fibre Channel Loopback
test 4-17
Private Loop Direct Attach 1-20
R
RA4000
description 1-7
powering up 1-14
system component 1-2
RA4000 Controller
ejector levers 1-15
failure 1-13
features 1-7
illustrated 1-7
latches 1-13, 1-14, 1-15, 1-16
LEDs
illustrated A-2
LEDs descriptions A-2
removing 1-13, 1-16
replacing 1-13
securing 1-14, 1-16
RA4000 Controller ejector
levers 1-13
RA4100
configuration 1-7
features 1-2
rear panel, status lights A-7
S
SCSI
status light A-7
SCSI-FCP protocol 1-20
secondary storage system flow chart
checking the link between the
Storage Hub 12 and the
Fibre Channel Tape
Controller 5-13
determine a bad link 5-6
Overview of the
Troubleshooting Flow
Charts 5-2
some Fibre Channel Tape
Controllers are
detected 5-7
servers
powering up 1-14
some Fibre Channel Array
Controllers are detected
primary storage flowchart 4-7
Some Fibre Channel Tape
Controllers are detected 5-7
status lights
location A-7
storage system
hub 12 1-2, 1-3
hub 7 1-2, 1-3
system configuration 1-20
T
tape controller
features 1-20
rear panel, status lights A-7
U
U1 Fibre Channel-to-SCSI
bridge 1-20