Compaq StorageWorks Fibre Channel Troubleshooting Guide

Introduction 1-15
Replacing the RA4000 Controller with Redundant Controller
1. Remove the Fibre Channel cable attached to the GBIC in the failed RA4000 Controller.
2. Squeeze the tabs on either side of the GBIC
, then remove the GBIC by pulling it
straight out of the RA4000 Controller
.
2
2
3
1
Figure 1-14. Removing the Fibre Channel cable and GBIC
3. Squeeze the latches and pivot open the two ejector levers securing the RA4000
Controller.