Compaq StorageWorks Fibre Channel Troubleshooting Guide

1-16 Compaq StorageWorks Fibre Channel Troubleshooting Guide
4. Remove the RA4000 Controller by pulling it straight out of the chassis .
1
1
2
3
Figure 1-15. Removing the RA4000 Controller
5. Install the replacement RA4000 Controller by inserting it into the tracks in the rear panel
opening.
6. Push the controller in as far as it will go
and close both latches against the rear panel .
The levers on each latch should catch behind the metal lip, drawing the board into position
and securing it into place.
1
2
2
Figure 1-16. Installing the RA4000 Controller
7. Replace the GBIC and connect the Fibre Channel cable.