HP Designjet Z2100 Photo Printer Series - Quick Reference Guide

Tip You may need two people to handle a large roll.
5. Slide the new roll onto the spindle. Make sure the paper type is oriented as shown. If it is not, remove
the roll, turn it 180 degrees and slide it back on to the spindle. There are labels on the spindle showing
the correct orientation.
NOTE From the back of the printer, the blue stopper is insert into the right-side holder.
Ensure both ends of the roll are as close to the spindle stops as possible.
6. Put the blue paper stop on to the open end of the spindle, and push it towards the end of the roll.
7. Ensure the blue paper stop is pushed in as far as it goes; until both ends are against the stoppers.
If you are a regular user of different paper types, you can change rolls more quickly if you preload rolls of
different paper types on different spindles. Extra spindles are available for purchase, see
Accessories
on page 31.
Load a roll into the printer
There are two ways to load a roll. The easy loading procedure is recommended.
CAUTION To start these procedures you must have a roll loaded on the spindle. See Load a
roll onto the spindle on page 9.
ENWW Load a roll into the printer 11
Paper handling