HP Designjet Z6100 Printer Series - User's Guide

10.
Wind the excess paper onto the roll. Use the hub to turn the roll in the direction shown.
11.
Lower the printer window.
12.
Wait for the front panel to again prompt you to wind excess paper onto the roll.
13.
The printer will perform a color calibration if it has not already calibrated the paper type you are
using, and if color calibration is turned on. See
Color calibration on page 110.
14.
a) Select the paper category and paper type of the roll you are loading.
NOTE: If it is not clear which paper category or paper type to select, see Supported paper
types on page 28.
b) Select the length of the roll you are loading.
NOTE: If the paper that you are using has a paper-data barcode printed on the leading
edge of the roll, the paper information is automatically loaded into the printer.
Load a roll into the printer 35
Handle the paper