HP Designjet Z6100 Printer Series User's Guide

Avisos normatius
Aquest producte HP conté una bateria de liti ubicada en una placa base que pot necessitar un tractament
especial al final de la seva vida útil.
Fitxa tècnica de seguretat del material
Podeu obtenir les Fitxes tècniques de seguretat del material actuals dels sistemes utilitzats a la
impressora mitjançant l'enviament d'una sol•licitud a aquesta adreça: Hewlett-Packard Customer
Information Center, 19310 Pruneridge Avenue, Dept. MSDS,Cupertino, CA 95014, Estats Units
d'Amèrica
També disposeu d'una pàgina Web:
http://www.hp.com/hpinfo/community/environment/productinfo/
psis_inkjet.htm
Número de model normatiu
Per motius d'identificació normativa, aquest producte té un Número de model normatiu assignat. El
número de model normatiu de la vostra impressora és el BCLAA-0701 i el del rodet receptor és el
BCLAA-0702. Aquest número normatiu no s'ha de confondre amb els noms de marketing (HP Designjet
Printer series o HP Take-Up Reel for Designjet Printer series) ni amb els números de producte (Q####X,
on X és una lletra simple i # és qualsevol número).
Declaracions normatives
●
USA
●
Electro-Magnetic Compatibility (EMC)
●
FCC statements (USA)
The U.S. Federal Communications Commission (in 47 cfr15.105) has specified that the
following notices be brought to the attention of users of this product.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
●
Shielded cables
Use of shielded data cables is required to comply with the Class A limits of Part 15 of the FCC
Rules.
ATENCIÓ: Pursuant to Part 15.21 of the FCC Rules, any changes or modifications
to this equipment not expressly approved by the Hewlett-Packard Company may cause
harmful interference and void the FCC authorization to operate this equipment.
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference, in
which case the user will be required to correct the interference at their own expense.
214 Capítol 18 Informació legal CAWW
Informació legal