HP Designjet Z6100 Printer Series - Setup Poster (60 inch)

Page 9
x5
53
Use the clips provided to attach the sensor cable
to the lower cross-brace.
54
Remove the take-up reel deflector from the box.
55
Attach the take-up reel deflector by inserting the
left side of the deflector into the left deflector
support, and then inserting the right side of the
deflector into the right deflector support.
56
Carefully lift the central core tube. The central
core tube contains the take-up reel spindle.
57
Remove the take-up reel spindle from the core.
58
Remove the two take-up reel hubs.
59
Loosen the plastic nut on the black hub.
60
Connect the sensor cable to the rear of the
take-up reel motor.
Connect the sensor cable to the sensor unit
located on the right foot.