HP Designjet Z6100 Printer Series - Setup Poster (60 inch)
Page 4
x4
x4
x4
x2
18
Place a foot on the left leg. There are pins to
help you correctly position the foot. Do not
remove the anti-slip material from the wheel.
17
Notice that there is anti-slip material around
two of the wheels on the feet. DO NOT REMOVE
this material yet.
16
Use four screws to attach the cross-bar to the
legs.
15
22
Roll the stand assembly into its upright position.
21
Use four screws to attach the foot to the right leg.
Tighten each screw half-way, and then gradually
tighten each screw completely.
20
Position the other foot on the right leg. There are
pins to help you correctly position the foot.
Do not remove the anti-slip material from the
wheel.
19
Use four screws to attach the foot to the left leg.
Tighten each screw half-way, and then gradually
tighten each screw completely.
x1
Attach the left stand spacer to the top of the left
leg. It will "click" into place.