HP Designjet Z6100 Printer Series - Setup Poster (60 inch)

Page 2
Remove the packaging
Steps 1 to 4.
x2
Boxes
required
x2
x4
Assemble the stand
Box required
x2
Steps 5 to 24.
3
Remove the boxes shown.
2
Carefully cut the straps around the boxes. Make
sure that the boxes don't fall when the straps are
cut.
1
Remove the 4 upper plastic handles from the
sides of the box (two each side), and then
carefully remove the two side lids vertically.
5
Open the box that contains the stand.
Remove the two boxes marked L and R. Place
them on the floor as shown.
64
Remove the boxes shown. Lower the left side of the cross-brace onto the box
marked L and the right side of the cross-brace
onto the box marked R.
x2
This task requires 2 people.
Time required is 5 minutes.
5'
This task requires 2 people.
Time required is 20 minutes.
20'