HP Designjet Z6100 Printer Series - Setup Poster (60 inch)
Wait until this message appears on the front
panel.
Page 16
106
Unlock and remove the blue hub from the left end
of the spindle. Keep the spindle horizontal.
107
Place one of the two rolls of paper that came
with your printer in the middle of the take-up
reel deflector.
108
Make sure that the black hub on the right side of
the spindle is fully inserted into the roll of paper.
(No gap should exist between the spindle hub
and the roll.)
109
Slide the blue hub onto the spindle. Make sure
that the blue hub is fully inserted into the roll of
paper (no gap should exist between the hub and
the roll), and then lock the hub.
11 0
From the front panel, select the paper icon
and then press the OK button.
111
Select Load roll and then press the OK
button.
112 113
With the blue hub on the left, lower the spindle
into the printer.
1
2
1
2