HP Designjet Z6100 Printer Series - Setup Poster (60 inch)

91
Pull up and release the blue latch on top of the
carriage assembly.
Lift the blue latch to open the printhead cover.
92
Before removing the setup printheads, look at
each printhead and verify that each printhead
contains ink.
93
Remove all of the setup printheads.
94
Shake the printhead vigorously for about 15
second. Be careful not to strike it against any
surface because this can damage the printhead.
95
Remove the two protective covers on the new
printhead.
96
Lower all of the printheads vertically into their
correct positions. The printer "beeps" when each
printhead is correctly inserted.
97
Make sure that the printheads are correctly
seated. When all of the printheads are inserted,
the front panel prompts you to "Close printhead
cover and window".
98
Page 14
Remove the packing tape that is holding down
the printhead carriage latch.