HP Designjet Z6100 Printer Series - Setup Poster (42 inch)

Page 7
Assemble the bin
This task requires 1 person.
Time required is 7 minutes.
Box required
x1
x4
Steps 39 to 46.
38
Remove the anti-slip material from the two rear
wheels on the stand assembly.
39
Remove the two brackets from the box that
contains the stand and the bin.
Note: The brackets are marked L and R.
40
Use four screws to attach the brackets to the
lower part of the printer legs. (Each bracket
requires two screws.)
41
Attach the two plastic brackets to the top part of
the printer legs. Insert the tab at the bottom of the
bracket into the leg, and then 'click' the top of
the bracket into place.
43
Insert the two bin arms into the bin cross-bar.
42
Remove the bin assembly from the box that
contains the stand and the bin.
44
Insert the bin cross-bar into the two plastic
brackets.
7'
HP DesignJet Information Engineering