HP Designjet Z6100 Printer Series - Setup Poster (42 inch)

Page 6
x1 x2
x2 x4
x2
x4
x4
37
Remove the two foam end-packs, and then
remove the plastic covering from the printer
engine.
36
Use the hand holds at the rear of the printer
engine to carefully lift the printer to its upright
position. HP recommends four people to
complete this task.
35
Remove the pallet before lifting the printer to its
upright position.
34
Rotate the printer until the back of the printer
rests on the spare box and the consumables box,
and the wheels with the anti-slip material touch
the floor.
33
Rotate the printer onto the spare box and the
consumables box. HP recommends four people
to complete this task.
32
Place the spare box and the comsumables box
against the rear of the printer box. The arrows on
the boxes must point towards the printer box.
Make sure that the anti-slip material is attached
to the two rear wheels.
31
Use two screws to attach the left side of the stand
to the printer. Make sure that the screws are fully
tightened.
30
Use one screw to attach the right side of the
stand to the printer engine. Make sure that the
screw is fully tightened.
HP DesignJet Information Engineering