HP Designjet Z6100 Printer Series - Setup Poster (42 inch)
Page 5
x1 x1
x2
Attach the printer engine to the
stand
This task requires 4 people.
Time required is 15 minutes.
Boxes required
x4
2
1
2
1
1
Steps 26 to 38.
29
Lift the stand assembly onto the printer engine.
The anti-slip material should face the rear of the
printer.
28
Pull open the protective plastic from the base of
the printer (1), and then remove the two desiccant
bags (2).
27
Remove the two packing pieces shown.
26
Remove the eight plastic handles, and then
remove the box shown.
25
Position the left and right leg covers on the front
of the legs (1), and then clip the rear edge (2)
into place.
24
Attach the right stand spacer to the top of the
right leg. It will âclickâ into place.
23
Attach the left stand spacer to the top of the left
leg. It will âclickâ into place.
x8
x2
15 '
HP DesignJet Information Engineering