HP Designjet Z6100 Printer Series - Setup Poster (42 inch)

Right side.
Page 3
x4 x2
x2
13
Lower the right leg onto the right side of the
cross-brace. The right leg will fit only on the right
side of the cross-brace.
12
Use two screws on the outside of the left leg to
attach the left leg to the cross-brace.
11
Use four screws on the inside of the left leg to
attach the left leg to the cross-brace.
10
Lower the left leg onto the left side of the
cross-brace. The left leg will fit only on the left
side of the cross-brace.
9
Remove the left leg from the box, and then
remove the two pieces inside the leg.
8
Locate the bag of screws and the screwdriver
provided. Notice that the screwdriver is slightly
magnetic. Because spare screws are supplied,
some screws will remain unused after assembly
of the printer.
7
Lower the left side of the cross-brace onto the box
marked L and the right side of the cross-brace
onto the box marked R.
x4
14
Use four screws on the inside of the right leg to
attach the right leg to the cross-brace.
HP DesignJet Information Engineering