HP Designjet Z6100 Printer Series - Setup Poster (42 inch)

Page 15
100
Wait until this message appears on the front
panel.
Use the hubs to wind the excess paper onto the
spindle.
9998
104
Use the hubs to wind the excess paper onto the
spindle.
105
Confirm the paper type and paper length of the
roll that you loaded into the printer. This
information is included on the packaging label.
103
Press the OK button when this message appears
on the front panel.
102
Lower the printer window.
101
On the front panel, select the paper type and
paper length of the roll that you loaded into the
printer, and then press the OK button.
The printer will automatically perform paper
advance and printhead alignment. During this
process the printer will advance the paper up to
3 m (~10 feet) before printing.
Windows users can proceed with
software installation.
Macintosh users must wait for the
printhead alignment.
HP DesignJet Information Engineering