HP Designjet Z6100 Printer Series - Setup Poster (42 inch)

Page 13
2
2
1
1
85
Slide one the rolls of paper that came with your
printer onto the spindle. Make sure that the
paper is oriented as shown.
84
Unlock and remove the blue hub from the left
end of the spindle. Keep the spindle horizontal.
8382
Remove the spindle from the printer.
89
On the front panel, select the paper icon and
then press the OK button.
88
With the blue hub on the left, lower the spindle
into the printer.
87
Put the blue hub onto the spindle. Make sure that
the blue hub is fully inserted into the roll of paper
(no gap should exist between the spindle hub
and the roll), and then lock the hub.
86
Make sure that the black hub on the right side of
the spindle is fully inserted into the roll of paper.
(No gap should exist between the spindle hub
and the roll.)
Select Load roll and then press the
OK button.
HP DesignJet Information Engineering