HP Designjet Z6100 Printer Series - Setup Poster (42 inch)

10'
Page 12
81
Wait until the Ready for paper message
appears on the front panel.
80
Close the printer window.
79
Make sure that the blue latch is correctly
engaged, and then lower the latch.
78
Close the carriage assembly cover.
77
If a "Reseat" message appears on the front
panel, check that all of the protective tape has
been removed, and then firmly reseat the
printheads. If the problem persists, refer to the
HP Start-Up Kit CD/DVD.
76
Make sure that the printheads are correctly
seated. When all of the printheads are inserted,
the front panel prompts you to "Close
printhead cover and window".
75
Lower all of the printheads vertically into their
correct positions. The printer 'beeps' when each
printhead is correctly inserted.
Load the paper
This task requires 1 person.
Time required is 25 minutes.
Box required
x1
Steps 82 to 105.
25'
HP DesignJet Information Engineering