HP Designjet Z6100 Printer Series - Setup Poster (42 inch)

2'
Page 10
63
Follow the same instructions to insert the other
seven ink cartridges.
64
Wait until this message appears on the front
panel.
65
Pull open the maintenance cartridge door, which
is located on the right side of the printer.
66
Remove the transparent shipping tray.
Insert the maintenance cartridge, pushing it in
and down until it 'clicks' into place, and then
close the maintenance cartridge door.
62
The printer 'beeps' when the cartridge is correctly
inserted.
61
Push the ink cartridge drawer back into the
printer until the drawer locks into position.
60
Place the ink cartridge in the ink cartridge
drawer. The arrow on the front of the ink
cartridge should point upwards.
Note that there are marks on the drawer to show
the correct location to place the cartridge.
59
Shake the ink cartridge vigorously for about
15 seconds. Be careful not to strike it against
any surface because this can damage the
cartridge.
HP DesignJet Information Engineering