HP Designjet Z6100 Printer Series - Quick Reference Guide

NOTE: The automatic paper-cutter is disabled when the take-up reel
is in use.
Unload a roll from the take-up reel
1.
At the printer's front panel, select the
icon, then Paper unload >
Unload roll.
The printer advances the paper to allow for cutting.
2.
Lift the take-up reel deflector to its upright position.
Switch the wind-direction switch to the Off position. The switch is in the off
position when it is centered (in other words, when the switch is neither in position
1 nor position 2).
3.
Remove the loop-shaping core.
Use the winding button on the take-up reel motor to wind the excess paper
around the take-up reel spindle.
4.
Press the OK button on the front panel.
5.
The printer knows if the type of paper that is loaded is suitable for the automatic
paper-cutter. The paper is cut if it is suitable. If the paper is not suitable, cut the
paper manually.
22 Chapter 2 Handle the paper
Handle the paper