Reference Guide

hp psc 2500 series
chapter 6
70
fax
redial a busy or unanswered number automatically
You can set your HP PSC to redial a busy or an unanswered number
automatically. The default setting for Busy Redial is Redial. The default setting for
No Answer Redial is No Redial.
1 Press Setup.
2 Do one of the following:
– To change the Busy Redial setting, press 4, and then press 3.
This selects Advanced Fax Setup and then selects Busy Redial.
– To change the No Answer Redial setting press 4, and then press 4
again.
This selects Advanced Fax Setup and then selects No Answer Redial.
3 Press to select Redial or No Redial.
4 Press OK.
use error correction mode (ECM)
ECM eliminates data lost due to poor phone lines by detecting errors that occur
during transmission and automatically requesting retransmission of the erroneous
portion. Phone charges are unaffected, or might even be reduced, on good
phone lines. On poor phone lines, ECM increases sending time and phone
charges, but sends the data much more reliably. Turn ECM off (the default setting
is on) only if it increases phone charges substantially and you are willing to
accept poorer quality in exchange for reduced charges.
1 Press Setup.
2 Press 4, then press 7.
This selects Advanced Fax Setup and then selects Error Correction Mode.
3 Press to select Off or On.
4 Press OK.
Advanced Fax Setup
1. Fax Reports Setup
2. Answer Ring Pattern
3. Busy Redial
4. No Answer Redial
5. Automatic Reduction
6. Backup Fax Reception
7. Erro r Cor re ctio n Mode
Busy Redial
1. Redial
2. No Redial
No Answer Redial
1. No Redial
2. Redial