Setup Guide

ManualsBrandsHP ManualsAll in One PrinterHP PSC 2355 All-in-One Printer

Development Company, L.P.

Title in HP Futura Book

14-20 pt., centered

Subtitle in 10-14 pt., centered, white

English

Arabic

Bahasa

Português

Hrvatski

Cesky

Dansk

Nederland

Suomi

Français

Deutsch

Greek

Hangul

Hebrew

Magyar

Italiano

Español

Magyar

Italiano

Japanese

Español

Norsk

Português

Russian

Simplified

Chinese

Slovencina

Slovenšcina

Español

Svenska

Traditional-

Chinese

Thai

Türkçe

Ukrainian

Horizontal cover image:

Replace this guideline area

with either a cropped product

photograph or a straight-on

front-view illustra tion

HP Photosmart 2600/2700 series all-in-one

User Guide

HP Photosmart 2600/2700 series all-in-one

User Guide

Development Company, L.P.

Title in HP Futura Book

14-20 pt., centered

Subtitle in 10-14 pt., centered, white

English

Arabic

Bahasa

Português

Hrvatski

Cesky

Dansk

Nederland

Suomi

Français

Deutsch

Greek

Hangul

Hebrew

Magyar

Italiano

Español

Magyar

Italiano

Japanese

Español

Norsk

Português

Russian

Simplified

Chinese

Slovencina

Slovenšcina

Español

Svenska

Traditional-

Chinese

Thai

Türkçe

Ukrainian

Start Here

Important: Do not connect the USB cable until

Step 16 or software may not install properly.

Follow the steps in order.

Remove all tape

Locate components

Windows CD

Macintosh CD

User Guide

print cartridges

power cord and

adapter

control-panel overlay

(may be attached)

USB cable*

HP PSC 2350 series all-in-one Setup Guide

* Purchased separately.

The contents of your box may differ.

Lift the access

door and remove

tape inside the left

side of the device.

If you have problems during setup, see Troubleshooting in the last section.

Summary of content (8 pages)

PAGE 1
Start Here Important: Do not connect the USB cable until Step 16 or software may not install properly. Follow the steps in order. 1 If you have problems during setup, see Troubleshooting in the last section. 2 Remove all tape Lift the access door and remove tape inside the left side of the device. 3 Locate components Title in HP Futura Book 14-20 pt., centered Subtitle in 10-14 pt.
PAGE 2
4 Attach the control-panel overlay (if not attached) a Position the controlpanel overlay above the device. b Press down firmly on all edges of the overlay to secure it. The control-panel overlay must be attached for the HP all-in-one to work! 5 Lift the color graphics display Raise the color graphics display. For best viewing, remove the protective film from the display.
PAGE 3
7 Connect the power cord and adapter 8 Press the On button and configure On a After you press the On button, the green light flashes, and then becomes solid. This may take up to a minute. b Wait for the print cartridge prompt before continuing. 9 Open access door Lift the access door until it stops. 10 Remove tape from both cartridges Pull the pink tab to remove the tape from both print cartridges. Do not touch the copper-colored contacts or retape the cartridges.
PAGE 4
11 Insert the tri-color print cartridge The device must be On before you can insert the print cartridges. a Hold the tri-color print cartridge with the HP label facing up. b Place the tri-color print cartridge in front of the left slot. c Push the cartridge firmly into the slot until it snaps into place. 12 Insert the black print cartridge a Hold the black print cartridge with the HP label facing up. b Place the black print cartridge in front of the right slot.
PAGE 5
13 Align the print cartridges a Press OK at each of the prompts on the control panel to start print cartridge alignment. The alignment may take a few minutes. b After the page prints, alignment is complete. Check the color graphics display for the status, and then press OK. If it fails, see Troubleshooting in the last section. Recycle or discard the alignment page. If you are not connecting the device to a computer, continue to the User Guide for information on how to get started.
PAGE 6
16 Connect the USB cable Windows Users: Macintosh Users: You may have to wait several minutes before you see the onscreen prompt to connect the USB cable. Once the prompt appears, connect the USB cable to the port on the back of the HP all-in-one, and then to any USB port on your computer. Connect the USB cable to the port on the back of the HP all-in-one, and then to any USB port on your computer. If you do not see this screen, see Troubleshooting in the last section.
PAGE 7
17 Continue software installation Windows Users: Macintosh Users: If you do not see this screen, see Troubleshooting in the last section. Follow the onscreen instructions. Complete the Sign up now screen. a Double-click the HP All-in-One installer icon. b Make sure you complete all screens, including the Setup Assistant.
PAGE 8
Troubleshooting *Q5786-90221* *Q5786-90221* Q5786-90221 Problem: A Carriage Jam message appears. Action: Open the access door. Remove the tape from inside. Turn the power off, and then wait one minute. Turn the power on again. Problem: The Check Print Cartridge message appears after you insert print cartridges or the print cartridge alignment fails. Action: Remove print cartridges. Make sure you remove all tape from copper contacts. Re-insert the cartridges, and then close the access door.