User's Manual

Page is used to enlarge a 10 x 15 cm (4 x 6 inch) photo to create a full-size
borderless copy. When copying a photo, you might want to use the photo print
cartridge for superior print quality. With the tri-color and photo print cartridges
installed, you have a six-ink system. For more information, see Use a photo print
cartridge.
Note In order to achieve a borderless print without changing the proportions
of the original, the HP All-in-One might crop some of the image around the
margins. In most cases, this cropping will not be noticeable.
To copy a photo onto a full-size page from the control panel
Note This feature will not work correctly if the glass and lid backing are not
clean. For more information, see Clean the HP All-in-One.
1. Load letter or A4 photo paper in the paper tray.
Note In order to make a borderless copy, you must have photo paper (or
other specialty paper) loaded. If the HP All-in-One detects plain paper in
the paper tray, it will not make a borderless copy. Instead, your copy will
have borders.
2. Load your original photo face down on the right front corner of the glass.
Position the photo on the glass so the long edge of the photo is along the front
edge of the glass.
3. Press Reduce/Enlarge.
4.
Press
until Fill Entire Page appears, and then press OK.
5. Press Start Copy Color.
Tip If the output is not borderless, set the paper size to Letter
Borderless or A4 Borderless, set the paper type to Photo Paper, set the
Photo enhancement, and then try again.
– For more information on how to set the paper size, see Set the copy paper size.
– For information on how to set the paper type, see Set the copy paper type.
– For information on how to set the Photo enhancement, see Enhance light
areas of your copy.
Chapter 7
52 HP PSC 1600 All-in-One series
Use the copy features