Reference Guide

hp psc 1300 series

chapter 11

hardware installation troubleshooting

Use this section to solve any problems you might encounter while installing the

HP PSC hardware.

problem possible cause and solution

I received a message to

attach the front panel

cover

The front panel cover is not attached, or it is attached incorrectly.

to attach the front panel cover

1 Remove the adhesive backing from the front panel cover.

2 Raise the lid of the HP PSC. Place the front panel cover into the

recess and stick it into place.

Note: The HP PSC will not work until you attach the front panel

cover.

My HP PSC does not

turn on

Make sure each of the power cords is firmly connected, and wait a

few seconds for the HP PSC to turn on. Also, if the HP PSC is plugged

in to a power strip, make sure the strip is turned on.

step 1

step 2