Reference Guide

reference guide
maintain your hp psc
35
After you have removed the plastic tape, install the print cartridge
immediately to prevent the ink from drying in the nozzles.
5 Hold the black print cartridge with the HP label on top. Slide the print
cartridge at a slight angle into the right side of the print carriage.
Press firmly until the print cartridge snaps into place.
Caution! Do not attempt to push the cartridge straight into the slot.
It must slide in at a slight angle.
6 Hold the tri-color print cartridge with the HP label on top. Slide the print
cartridge at a slight angle into the left side of the print carriage.
Press firmly until the print cartridge snaps into place.
Caution! Do not attempt to push the cartridge straight into the slot.
It must slide in at a slight angle.
Note: You must install both print cartridges in order for your HP PSC to
work.
You can also refer to the label that is located on the inside of the print-
carriage access door for information on installing the print cartridges.
7 Close the print-carriage access door. Within a few minutes, a print
cartridge alignment page prints. You will need to align the print
cartridges.
For information on aligning the print cartridges, see align the print
cartridges on page 37.